Toro P220-27-08 Pressure Regulator Valve – 2 in. NPT

Some valves open and close. This one’s made to handle pressure, surges, and jobs that can’t afford failures. The P220-27-08 is a 2-inch valve that handles tough installs without giving you problems later.

Why It’s Built Like This

This valve is rated to 220 psi and ready for high-pressure, pump-fed systems. It’s made for commercial zones, municipal work, or anywhere a smaller valve won’t cut it.

Takes the Hit and Keeps Working

The Spike Guard™ solenoid shrugs off lightning up to 20,000 volts. Power surges that take out other valves won’t touch this one. It keeps you from tearing up boxes and tracking down solenoid failures after every storm.

EZReg Pressure Control

Adjust downstream pressure from the top; no teardown required. Factory- or field-installed. You’re not reaching into the box with tools or swapping out parts just to dial in pressure.

Lighter Electrical Load

The solenoid pulls half the amps of older models. That means more valves per controller, longer wire runs, and less cost up front.

Where It Fits

• 2-inch NPT inlet
• Works in medium- to large-scale installs
• Fits valve boxes easily and stays clean
• Handles power surges and high-pressure cycles
• Easy to maintain, less downtime, fewer callbacks

Who It’s For

You’re not cutting corners. You need something that holds up under pressure and doesn’t waste your time on the job. This one just works.

DIRECTIONS FOR USE:

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulations.

LABEL:

For additional information on this product please reference the CDMS label database listed below